Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
The name of this software is World Machine. What is the first (bolded) word in the name?:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: JakBB
« on: June 14, 2017, 06:38:43 AM »

Use a height selector to select only the ocean, then use a blur on the selector to make it fall off gradually and subtract the output from the original terrain, which you need to combine on "add" to a constant generator, so that when you subtract the ocean you don't go under the lowest value and end up with a flat ocean floor again
Posted by: smb3d
« on: June 13, 2017, 06:10:23 PM »

Use a  height selection to select just the flat floor. You could draw a mask in the layout generator that matches the shape of your island roughly and set the parameters so that it is higher in the island part and lower where the ocean is. Now use a combiner node to combine the two together using your height selector as a mask. You could subtract the layout generator from your original terrain. It will take some fiddling, but should be workable.
Posted by: Jakerod
« on: May 27, 2017, 07:38:21 PM »

I grabbed some SRTM data of an island that I'm trying to make. The SRTM data has the ocean flat at 0m. I've been trying to figure out how to make a new ocean floor that ramps down from the island but haven't managed to do it. I feel like I have tried every filter about six times in various combinations of selections with no luck. I was wondering if anyone had any ideas. I'm trying to keep the shape of the island mostly intact. Small deviations are okay though if they are necessary.

Does anyone have any thoughts?