Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - navett52

Pages: [1]
Guest Forum / How to combine tiled outputs?
« on: June 14, 2017, 01:41:16 PM »
Is there any good software for stitching tiled outputs together? Instead of having to place each picture next to the correct one by hand in something like photoshop is there any software that can read the image names and put them together appropriately?

Guest Forum / Re: Combine two islands made with layout generators?
« on: June 14, 2017, 01:10:40 PM »
This is my original post, but it was taking so long to get approved I re-posted in the guest board since it seemed more lively. It's approved now though, but here's the link:

I was using add at .5 strength, but I had tried max at some point too. I'll try again within the next couple of days just to be safe, and I'll even post my node tree too to hopefully help the transparency.

I don't know how I would use a chooser to accomplish this

Guest Forum / Combine two islands made with layout generators?
« on: May 30, 2017, 01:32:43 PM »
Hi, I have a continent that I want to make with multiple smaller islands off of it's coast. I want to keep the continent and each island in their own layout generators since each piece of land will have a different terrain so this will make things easier. Here are some pictures to hopefully make sure I'm not being confusing:

This is the continent:

This is an island off of it's coast:

This is what I want it to look like, but I'm getting this result by making the island within the same layout generator as the continent which is not how I want to do it:

This is me attempting to use a combiner to make both islands show up while they're in their own layout generators, but no setting on the combiner lets me make it look like the above photo:

The question again is how can I make both these islands show up like in the 3rd photo, but have them be within their own layout generators?

Thanks for any responses!

Hi, I'm having some trouble with combiners and layout generators..

I'm making a map that has 2 islands. Each island is housed within it's own Layout Generator.

First Island:

Second Island:

I want them to be combined, so I'm trying to use a combiner but none of the settings seem to do what I want it too..

Below are what I want, and what is happening. I'd post my node tree but it's literally just the two layout generators and the combiner. Though if you'd really like to see it I can upload it later.

Desired Result (both islands in same layout generator):

Actual Result (using a combiner set to add, strength = .5):

Thanks to anyone who responds!

Pages: [1]