• Welcome to World Machine Community. Please login or sign up.
September 18, 2019, 02:49:28 pm


Read the Development Diary for an inside look at World Machine's progress!

e2's Carved Ready for use!

Started by e2clipse, May 25, 2014, 06:11:27 pm

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.


May 25, 2014, 06:11:27 pm Last Edit: May 26, 2014, 06:16:53 am by e2clipse
Im not going to say a whole lot about it
But i think it will be a very nice tool
And with the manipulator i build it will be even more usefull

This macro is done
And i tend to like the way it carves. I have a comparismant picture
Note that this macro uses the flow to carve it in(or out) so theres no flowmap on the comparismant
But theres a mask output aswell but i didnt use that :P

Let me know what you all think!

Have fun with it
If you are reading this your wasting your time :D


Thank Eclipse, i will give it a go since i was looking to have less pronounce effect then the erosion and your macro seem good to do just that.

We made a 30 km x 30 km world and it is impossible to get nice detailing on small mountain on such a big world.

Regards Peter


Alright then :) i hope it works out for you
Would like to see some results if i may

U know you could always download the roughness selector from the library(its not mine)
Put it between nikitas frequency splitter and combiner...low and high
Adjust it...and you will have a flowmap 2 to use in carved
Several ways actually
If you are reading this your wasting your time :D


Hi eclipse,

I get an error on selected the macro but your ultra manipulator is working perfectly, i am on the latest stable build.

Regards Peter


May 26, 2014, 11:41:32 pm #4 Last Edit: May 27, 2014, 12:04:44 am by e2clipse
Thats weird i will look into that..good to hear the manipulator does its job :)
Thanks for the feedback!


Where all build in

Version 1.2 of carved is out! I hope no errors this time
If you are reading this your wasting your time :D


Iff it isnt working this time...i will rebuild it again and check for any weak spots
Im not sure why its not working...
If you are reading this your wasting your time :D



Yes! Nice well hope it works for Peter aswell then
If you are reading this your wasting your time :D


Hi eclipse,

I tried the equalizer and i also get unknown error while selecting the macro.

So for me both the carving and equalizer get unknown error while the ultra manipulator work fine.

Regards Peter


Carved is re uploaded in the topic...and library
You can try again iff you like...someone else has used it and succeeded with doing so
If you are reading this your wasting your time :D

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Please leave this box empty:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

Shortcuts: ALT+S save/post or ALT+P preview