• Welcome to World Machine Community. Please login or sign up.
 
August 22, 2019, 06:14:51 am

News:

Read the Development Diary for an inside look at World Machine's progress!


Variable falloff for a spline

Started by eagle4, July 24, 2014, 10:52:14 am

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

eagle4

I was thinking it would be really handy to have the ability to control the fall off distance for each vertex in a spline in the layout generator.

I like the way you can vary the height of each vertex, I'd just like the ability to control its falloff.

Perhaps there could be a way to control this with the breakup too, in case you want only a few verts in your spline but want tons of variety in the fall off, obviously within a range of values you set. (aka a max and minimum value)

Stephen

Yes -- variable width falloff is a very logical and important feature. The next dev release after the imminently upcoming one will be focusing on a lot of layout/shape improvements, so this is high on my list for that.
-- Stephen Schmitt
- Creator of World Machine

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Verification:
Please leave this box empty:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

Shortcuts: ALT+S save/post or ALT+P preview