Author Topic: Tiled DEM Heightmap Problem  (Read 1461 times)

0 Members and 1 Guest are viewing this topic.


  • Guest
Tiled DEM Heightmap Problem
« on: January 06, 2015, 10:15:15 AM »
Hello all,

I followed the steps that were mentioned in a thread about how to bridge multiple height maps together. When I did the same steps with my dem height map files, this is what it looked like

I have a 8kx8k map with 16 2048x2048 tiles. 

I set my elevations in the tile file input, and in the project settings in general setup, but i'm getting the same results. i've been trying to figure this out for hours but I still get no where. Is there something i'm doing wrong or is there something i'm not setting up right? Oh, before I forget, I'm very new to WM well, I'm in the early noob stages of WM  :D. There are terms that I don't know yet, so screenshots are greatly appreciated. Thank you in advance for reading and helping  :)