• Welcome to World Machine Community. Please login or sign up.
May 20, 2019, 06:11:14 pm


Read the Development Diary for an inside look at World Machine's progress!

Mesh output size

Started by topofsteel, February 16, 2015, 04:00:43 am

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.


My mesh output size keeps changing. Every time I return to the device, it is the size of one grid square. I have to use the coordinate system pull down to refresh it even if I'm selecting the same coordinate system. My project is set up 24km square with lower right corner at -12 and the upper left at 12, effectively placing the origin at the center. But even after refreshing the size as described above, the origin of the mesh output remains at the center of the one grid square. And if I select km as my output size, it's magnitudes larger than my project, which I thought was in km anyway? What are World Machine units? I need to pin down a reliable way of exporting geometry with a consistent basepoint and scale. Can anyone advise me on this? Thanks.

Also, is there a way to turn on email notifications? I didn't see on option in my profile. Thanks.

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Please leave this box empty:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

Shortcuts: ALT+S save/post or ALT+P preview