• Welcome to World Machine Community. Please login or sign up.
 
July 15, 2019, 09:09:06 pm

News:

Read the Development Diary for an inside look at World Machine's progress!


"Edges" of mesh output

Started by posfan12, October 30, 2016, 09:17:08 pm

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

posfan12

When you normally view a height map in WM, the sides are "filled in" so you can't peek through. This is not the case for mesh output. Is there a way to configure WM to output those side faces as well?




Hotshot

I use a Macro to do it. Or use the Radial grad and set it to square to set side to 0

JakBB

or else resize your extent just millimeters towards the middle

posfan12

Quote from: Hotshot on November 02, 2016, 12:02:04 pm
I use a Macro to do it. Or use the Radial grad and set it to square to set side to 0

Could you upload the macro? Is that possible?


Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Verification:
Please leave this box empty:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

Shortcuts: ALT+S save/post or ALT+P preview