• Welcome to World Machine Community. Please login or sign up.
 
April 25, 2019, 01:37:18 pm

News:

Read the Development Diary for an inside look at World Machine's progress!


Island with SRTM data

Started by Jakerod, May 27, 2017, 07:38:21 pm

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Jakerod

I grabbed some SRTM data of an island that I'm trying to make. The SRTM data has the ocean flat at 0m. I've been trying to figure out how to make a new ocean floor that ramps down from the island but haven't managed to do it. I feel like I have tried every filter about six times in various combinations of selections with no luck. I was wondering if anyone had any ideas. I'm trying to keep the shape of the island mostly intact. Small deviations are okay though if they are necessary.

Does anyone have any thoughts?

smb3d

Use a  height selection to select just the flat floor. You could draw a mask in the layout generator that matches the shape of your island roughly and set the parameters so that it is higher in the island part and lower where the ocean is. Now use a combiner node to combine the two together using your height selector as a mask. You could subtract the layout generator from your original terrain. It will take some fiddling, but should be workable.

JakBB

Use a height selector to select only the ocean, then use a blur on the selector to make it fall off gradually and subtract the output from the original terrain, which you need to combine on "add" to a constant generator, so that when you subtract the ocean you don't go under the lowest value and end up with a flat ocean floor again

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Verification:
Please leave this box empty:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:

Shortcuts: ALT+S save/post or ALT+P preview