e2's Carved Ready for use!

Im not going to say a whole lot about it
But i think it will be a very nice tool
And with the manipulator i build it will be even more usefull
:slight_smile:

This macro is done
And i tend to like the way it carves. I have a comparismant picture
Note that this macro uses the flow to carve it in(or out) so theres no flowmap on the comparismant
But theres a mask output aswell but i didnt use that :stuck_out_tongue:

Let me know what you all think!

Have fun with it

Thank Eclipse, i will give it a go since i was looking to have less pronounce effect then the erosion and your macro seem good to do just that.

We made a 30 km x 30 km world and it is impossible to get nice detailing on small mountain on such a big world.

Regards Peter

Alright then :slight_smile: i hope it works out for you
Would like to see some results if i may

U know you could always download the roughness selector from the library(its not mine)
Put it between nikitas frequency splitter and combiner…low and high
Adjust it…and you will have a flowmap 2 to use in carved
Several ways actually

Hi eclipse,

I get an error on selected the macro but your ultra manipulator is working perfectly, i am on the latest stable build.

Regards Peter

Thats weird i will look into that…good to hear the manipulator does its job :slight_smile:
Thanks for the feedback!

Carved
MNPLTR
PQualizer

Where all build in 2.3.6.3

Version 1.2 of carved is out! I hope no errors this time

Iff it isnt working this time…i will rebuild it again and check for any weak spots
Im not sure why its not working…

Works now!

Yes! Nice well hope it works for Peter aswell then

Hi eclipse,

I tried the equalizer and i also get unknown error while selecting the macro.

So for me both the carving and equalizer get unknown error while the ultra manipulator work fine.

Regards Peter

Carved is re uploaded in the topic…and library
You can try again iff you like…someone else has used it and succeeded with doing so