Hi! Apologies for the many bugs in one post, let me try to mention all of them since there are quite a lot. Bug 1: The input of an output device and the output of the output device are not the same. I work with quite a lot of output devices and regularly find this error. Since I work in a multit…

Bug 2: The Create water device streams both up hill and does not generate lakes. For the streaming uphill I only have a screenshot in which you can vaguely see it. I did not intend to make a bug post at first hence the ‘bad’ screenshot. [image] Secondly it is amazing to be able to control the l…

Bug 3: Falloff = 0 in the shapes device is not falloff = 0. It simply is not a falloff of 0. The falloff is not fully straight which is rather annoying for masking. [image] For now, that’s it! Apologies for the 3 replies to the first message, but I was not allowed to send this many embedded im…

Bug 2: When a lake is ignored (either because the lake generation is turned off or because its below threshhold in size), WM can either carve through the drainage headwall, or make a river run uphill to get out of the lake basin. Both of these options are most useful for dealing with low quality or…

For Bug 3, I have a similar experience. For devices like Select Height, when the fallout is set to 0, I expect the grayscale image to be completely binary, but in fact, it is not. There are still some pixels between 0 and 1 at the edge of the shape. I can reproduce this issue in the 3xxx version, b…

i confirm that did also have such problem with selector devices but also did not test it on 4040+

Same issue, I used to pass it through a second Select Height or Terrace[Simple] device, to get that really sharp cutoff, both on 3.x and 4.x versions.

to fix this issue in my case i did use Curves filter set to max with lowest value on 0.000000000000001 dont know is that better than yours variants :thinking:

Bug 2: Unfornately I dislike the updated flow resture device due to the limitation, it will only fill basins which destroys a lot of shape (think about a volcano), so I am still using the old one. Thank you! Looking forward to seeing the updates on this :smiley: Bug 3: With the method you used i…

Couple things: Regarding Selectors: @Tomatiy @HYLK @A_Lingll in prior versions of WM, there was a small minimum falloff instead of allowing a binary mask. The HR device versions changes this to now allow a completely sharp edge. Shape falloff: Whether a mask or a heightfield, a step function f…

I found it, I hadn’t noticed it before :smiley: [image]

World Machine Community

Various Bugs - input/output - Water - Falloff

Bug Reports

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled